Min un Jo asked:


my father always said that the mcintosh is best for him when I was child.
so i wanna try it. I’ve searched for a few times.. but i’m not sure what’s better for me.

budget is about 700~900$.

inmate search

fanmegaman asked:


Ok here are the specifications for b&w speakers:

B&W Nautilus 801 loudspeaker Specifications
Sidebar 1: Specifications
Description: Three-way, reflex-loaded dynamic loudspeaker. Drive-units: 1″ (25mm) metal-dome tweeter, 6″ (150mm) woven-Kevlar-cone midrange unit, 15″ (380mm) paper/Kevlar-cone woofer. Crossover frequencies: 350Hz, 4kHz. Crossover type: third-order. Frequency response: 32Hz-22kHz, ±3dB. Sensitivity: 91dB/2.83V/1m. Nominal impedance: 8 ohms (3 ohms minimum). Recommended amplifier power: 50-1000W. Maximum recommended cable impedance: 0.2 ohms.
Dimensions: 43.7″ (1110mm) H by 20.6″ (522mm) W by 27.2″ (690mm) D. Net weight: 229 lbs (104kg). Here’s the link: http://www.stereophile.com/floorloudspeakers/207/index.html

I was thinking if the Mcintosh mc501 monoblock amplifier would match these speakers so here are the specs:

McIntosh MC501 monoblock power amplifier Specifications
Sidebar 1: Specifications
Description: Solid-state monoblock power amplifier with balanced (XLR) and single-ended (RCA) inputs and “Autoformer”-coupled output stage. Minimum sinewave continuous average power output: 500W into 8, 4, or 2 ohms (27dBW, 24dBW, 21dBW, respectively). Rated power bandwidth: 20Hz-20kHz. THD: 0.005% into 8, 4, or 2 ohms, 250mW to rated power output. IMD: 0.005% maximum if instantaneous peak output does not exceed twice the rated output for any combination of frequencies, 20Hz-20kHz, into 8, 4, or 2 ohms. Dynamic headroom: 1.8dB. Wideband damping factor: 100 at 8 ohms (equivalent to a source impedance of 0.08 ohms) Frequency responses: 20Hz-20kHz, +0/-0.25dB; 10Hz-100kHz, +0/-3dB. Sensitivity: 2.1V unbalanced input, 4.2V balanced input. Signal/noise ratio: 97dB, A-weighted (124dB below rated output), unbalanced and balanced. Input impedance: 10k ohms unbalanced, 20k ohms balanced.
Dimensions: 17.5″ W by 9.5″ H (including feet) by 14 7/8″ D (including front-panel knobs). Weight: 91.5 lbs (41.6kg) net, 105.5 lbs (48kg) Heres the link: http://www.stereophile.com/solidpoweramps/804mcintosh/index.html

I want mcintosh monoblocks only either the mcintosh mc501 monoblocks, mcintosh mc601 monoblocks or the mcintosh mc1000 monoblocks so anyone out there would tell me between these 3 models is best let me know ok.

sell cars

Xbox ThreeSixty asked:


I know that the type of subwoofer and the enclosure it is in as well as the environment it is in will determine the output level and the sound quality. But on top of those factors, is what type of amplifier would best for the purpose of sound quality?
Digital, AB, or Mono-Block.
I know that mono-blocks are used for their high rated power output and sometimes SQ.
One of the key factors I’m looking for too is minimal distortion.

Out of those class of amplifiers, which of the following companies below, are known for their sound quality?
Alphasonik
U.S. Amps
Audison
Boston Acoustics
Cadence (Not commonly known, but their stuff is amazing)
JL Audio
Cerwin Vega
Diamond Audio
DLS
Focal
American Bass
Image Dynamics
Rockford Fosgate
MB Quart
McIntosh
Orion
Soundstream
Sundown Audio
Zapco
and
DC Sound Labs

tow it yourself

MicD asked:


Just found a old akia reel to reel tape recorder. Trying to record some music that i downloaded on my computer. Can it be done, and how do i do it.

socaial promotion

leland asked:


in the metro philadelphia region.
Can take 7 inch reel and 10 inch reels

new site

sean h asked:


If so, how much and where?

also, how much recording time would one get from a regular 1′ reel on a 24 track recorder?

commercial mortgage

deonar asked:


It is in good condition, still working, and comes with the original instruction manual

new site

Vovvy Bictor asked:


So that it sounds like music

new site

steve s asked:


I don’t even have a reel to reel machine anymore, want to give copies to former band members for a 35 year reunion

Ferrari

dinkylinker asked:


You know like the semi pro types Akai use to make?

iodine